Local roofersFree to callNo forms to fill out
Serving Orange and nearby towns
Menu
Call (973) 858-1825
Metal Roofing

Metal Roof Coating Orange, NJ

A roofer in Orange can coat an aging metal roof with an elastomeric or silicone system that seals screw heads and laps, covers surface rust and reflects sun, as long as the panels have not rusted through. One call to (973) 858-1825 reaches a nearby roofer who coats metal roofs.

Coating a metal roof means adding a seamless, rubbery layer over the whole surface to seal it and protect the metal. Coatings target the common aging problems of metal: worn paint, surface rust, leaking fasteners and open laps. A coating is not a structural repair, so damaged panels and framing are handled first.

Coating systems for metal come down mostly to acrylic or silicone. Acrylic coatings stretch with the metal, reflect sunlight and can be recoated with the same material later. Silicone handles ponding water and UV well but bonds poorly to anything but more silicone later.

Preparation decides whether a coating lasts. The roof has to be cleaned of chalk, dirt and oil, rust has to be treated, and fasteners and seams have to be sealed before the base coat goes on. Rain or cold during curing can ruin a coating.

Metal Roof Coating is often paired with metal roof repair and roof coating, depending on the cause.

Need metal roof coating in Orange? Call (973) 858-1825 to reach a nearby roofing contractor.

Call now
The process

What happens during a metal roof coating

A metal roof coating is a system of steps, and each one matters.

  1. Inspect the roof

    Before anything else, the roof is inspected to confirm the panels and framing can support a coating. Test patches help pick the right primer.

  2. Clean the surface

    Pressure washing at a moderate setting and a cleaning solution prepare the surface. Everything has to be dry before primer goes on.

  3. Treat the rust

    Rusted areas are wire brushed and primed with a rust-inhibiting primer. Rust that has gone through is patched first.

  4. Seal fasteners

    Screws and laps are sealed and reinforced so the coating spans them without cracking. Penetrations and pipe boots get the same treatment.

  5. Base coat

    The coating is applied in one or more coats to reach the right dry film thickness. The roof is left to cure in dry weather.

What is included

Parts of a coating system

Surface prep

The roof is washed and degreased for good adhesion.

Fastener sealing

Leaking screws are replaced and sealed before the topcoat.

Elastomeric topcoat

Acrylic or silicone is applied at full thickness to seal and protect the metal.

Metal priming

Bare metal is primed to stop corrosion under the coating.

Lap sealing

Seams and laps get fabric and coating so water cannot wick in.

Related service

Metal Roof Restoration Orange, NJ

A metal roof restoration combines repairs and a coating system to give a tired roof another long run. The restoration starts with panel, fastener and trim repairs before the coating ever goes on.

A metal roof restoration in Orange makes sense when the framing and most panels are still in good shape. Restoration keeps the building closed and avoids hauling away the old roof. Ask the roofer which repairs are needed before coating and how thick the coating will be.

Related service

Metal Roof Painting Orange, NJ

Metal roof painting is a lighter job than coating, aimed at restoring color and rust protection rather than sealing leaks. Unlike a coating, paint does not stretch to seal seams or cover screw leaks.

A Orange roof with good fasteners and sound seams can be painted for color and protection. Prep is the same: clean, treat rust and prime before painting. If the roof has leaks, a coating is usually the better choice.

Local help

Metal Roof Coating Near Me

In Orange, many metal coating jobs are older exposed fastener roofs with faded paint and leaking screws. Across Orange and nearby communities including East Orange, Glen Ridge, Caldwell and Roseland, metal roofs on farm buildings and shops are frequent coating candidates, so catching rust before it eats through keeps a roof in the coating window.

Need metal roof coating around Orange? Call (973) 858-1825 for an Orange roofer who serves the towns around it too.

Roofs in this climate

Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, building ice dams that push water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Orange is busiest after a hard winter and before the next one.

Why call

Why not wait

Drier ceilings

Small roof problems caught early usually stay small repairs.

Roofers who know Orange

Local roofers see the same roofs and storm damage across Orange and nearby towns.

Straight answers

Ask your questions before you agree to anything.

Metal Roof Coating questions

Will a coating stop my metal roof from leaking?
A full coating system can stop leaks at screws and seams when the prep is done right. Rust holes and loose panels have to be repaired first, since a coating will not span a hole or hold a loose panel down. An inspection shows whether a coating will solve your leaks.
What type of coating works on a metal roof?
Acrylic and silicone are the two most common coatings for metal roofs. Acrylic recoats easily, while silicone resists standing water but limits future recoat options. The right choice depends on drainage and how you plan to maintain the roof.
What is the difference between painting and coating a metal roof?
A coating is many times thicker than paint and stretches to seal seams and fasteners. If the roof is leaking at screws or laps, a coating is the better fit; if it is dry and just faded, paint may be enough. Both need the same careful prep.
When will a coated metal roof need recoating?
A coating applied at the right thickness typically lasts ten to twenty years. Thicker applications last longer, and recoating before the coating wears through renews it without starting over. An inspection every year or two tracks coating wear.
Is my metal roof a good candidate for coating?
A coating works best on a metal roof that is worn on the surface but sound underneath. Severe rust, structural rot or failing panels rule out a simple coating. A roofer can test and confirm whether a coating will work.

More questions? Call (973) 858-1825

Other services that may help

  • Metal Roof Repair

    Metal roof repairs that stop leaks at the screws, laps and flashing, matched to exposed fastener and standing seam roofs alike.

    Learn more
  • Roof Coating

    Liquid-applied roof coatings that seal seams, reflect heat and add years to a roof, after the seams and blisters are repaired.

    Learn more
  • Commercial Roof Coating

    Coating systems that seal and reflect sun on commercial roofs, applied after repairs and cleaning.

    Learn more
  • Metal Roof Inspection

    An inspection that tells you what a metal roof needs now and what can wait, before small fastener problems become leaks.

    Learn more

Looking for something else?

See all roofing services

Talk to an Orange roofer about metal roof coating

Call now for Orange metal roof coating and help in the towns around it.

Talk to a local roofer(973) 858-1825Call now

Free to call. No forms to fill out.

Call (973) 858-1825